- Low Cost Solution for Installing Shower Rod on Sloped Wall
- All Mounting Hardware Provided Easy Installation - Screw Wall Mount into Wall; Snap Ball Joint Into Mount; Install Tension Rod Can Be Painted to Match Your Decor
- Non corrosive aluminum tension spring rod with a chrome or white finish and is .98in / 25mm in diameter with white hard rubber end caps; Simply pullout to desired length and clamp into position,NO twisting necessary
- No hardware needed for the rod,If over extended you can reload tension by pulling it completely apart and sliding the NON spring end of the smaller diameter piece into the larger diameter piece; Shortening possible by sawing off to a length of 20 cm.
- One angled wall mount and one matching rod are included; They are from the same German Brand
Our rods are designed and produced in Germany. They can be used as outdoor curtain tension rods, room dividers or tension rods in your bathroom. Install Wall Mount Portion, Snap Ball Joint with Receiving Cup into Wall Mount then Insert Tension Spring Rod. Simply remove one of the rubber end caps before using the angled wall mount.
